Grandstream Networks GXV3500 User Manual page 51

 Show Regions:
 Enable Motion Detection:
There are total 16 regions be available for MD configuration, from region 0 to 15.
Select and highlight the number of region to configure the MD and the sensitivity.
Alarm Action:

Record Video From Pre Alarm Up to XXX seconds to After Alarm Up to XXX seconds:
 Voice Alarm to SIP Phone:
 Alarm Output:
 Upload to Alarm Center:
 Upload to Alarm HTTP Server:
•
Email and FTP upload JPEG and Store it to SD driver:
Grandstream Networks, Inc.
When checked, Motion Detection region with number will be
displayed as a white rectangle in the screen. When "Edit" clicked,
the Rectangle will become Red, as shown in Figure 16-1.
When checked, Motion Detection is enabled.
This setting to allow configure pre/post alarm video for
applications to utilize. MJPEG is NOT supported for this feature.
If a SIP server or peer IP device configured, check this will allow
MD event to trigger alarm SIP call to pre-configured number.
Select will allow MD to send alarm to Alarm Output interface.
When checked, the alarm video will be transferred to Alarm
Center, like Grandstream free GSurf _Pro VMS software, or other
rd
3 party Alarm Center.
When checked MD alarm will be send to 3
via programmed Grandstream HTTP API.
When checked, snapshots of trigger moment will be emailed to
pre-configured email account and also uploaded to FTP server if
configured, will also be stored to the microSD card inserted.
The pre/post alarm snapshot numbers can be configured based on
time (in second) to meet user's requirement.
GXV3500 User Manual
Firmware Version 1.0.1.94
rd
party HTTP server
Page 51 of 82
Last Updated: 05/2016