Table of Contents
Advertisement
3)
The PC with Ethernet card and Internet Protocol (TCP/IP) installed.
4)
Power socket.
3.
Preparation of tools and cables: Phillips screwdriver, network cable.
2.4
Hardware Installation
Before installing the device, make sure the broadband service is normal. If you cannot access,
please contact operators (ISP) to resolve the problem. After successfully accessing to the network,
follow these steps to install the device. The power plug must be removed during installation.
1.
Installed on the work bench
Place the device on a stable workbench, and the installation steps are as follows:
1.
Place the device on a sufficiently large, stable and properly grounded workbench, with its bottom
up;
2.
Remove the adhesive protective paper from the foot pad, and stick the 4 pads in the 4 round slots
at the bottom of the casing respectively.
3.
Flip over the device, and place it on the workbench stably.
2.
Install on the standard rack
Install the device on a 19-inch standard rack, and the installation steps are as follows:
1.
Check the grounding and stability of the rack.
2.
Install the two L-shaped brackets in the accessories on both sides of the device panel, and fix
them with the screws in the accessories.
3.
Place the device in the appropriate location in the rack, and support it using a tray.
4.
Secure the L-shaped brackets on the guide slots (as shown in the figure below) fixed at both ends
of the rack.
http://www.level1.com
Figure 2_3 Product rack installation drawing I
Chapter 2 Hardware Installation
Page 6
Advertisement
Table of Contents
