Static Route Settings - LevelOne GBR-4001 User Manual

Chapter 7 Advanced Configuration
the fixed IP access to the default Internet line in Network parameters —> WAN port
configuration page, or directly enter the Start--> Configuration wizard > Network parameter
spage to configure the line. After the default Internet access line is configured correctly, the
system-reserved NAT rules corresponding to the default line will be automatically generated, and
the NAT function is automatically enabled.
And this enterprise provides four internal servers for external access, so it is also necessary to set
an NAT rule with the type of "One2One".
Configuration steps are follows:
The first step is to enter the Advanced configuration -> NAT and DMZ configurations ->NAT
rules page, and click <Add new entry>.
The second step is to enter the NAT rules configuration page, and fill in "Server" in the "Rule
name".
The third step is to select "NAT type" as "One2One".
The fourth step is to fill in202.1.1.131in the "External starting IP address". Fill
in192.168.1.200and 192.168.1.203 in "Internal starting IP address" and "Internal ending IP
address" respectively.
The fifth step is to select the rule-bound interface as WAN1 port.
The sixth step is to click <Save>, and the NAT rule is configured successfully.
Figure 7_9 NAT rule Settings —One2One
7.2

Static Route Settings

This section describes the Advanced Configuration-> Routing configuration page and
configuration methods.
http://www.level1.com Page 50