Account Settings - LevelOne GBR-4001 User Manual

Number of address pool addresses: Sets the total number of the addresses in the address pool.
Server IP address: The virtual interface IP address of the tunnel server. This address is not
included in the address pool. Please confirm that the address and the address pool that is
configured are located on the same network segment.
Master/standby DNS server: When the device is configured as the PPTP/L2TP server, it can
assign the DNS address for the PPTP/L2TP clients, so that users can browse web pages
through the DNS address assigned on the server line after connecting to the server, which can
solve the problem that users can open the internal network of the server after dialing through
the VPN but cannot open the web pages.
Encryption mode: Sets the data encryption mode, with the options of MPPE encryption, no
encryption. Note: In the use of MPPE encryption mode, MS-CHAPV2 password
authentication method must be selected.

12.1.3.2 Account Settings

The following describes the meaning of the parameters for the PPTP server to configure accounts
for the PPTP client.
Tunnel name: Custom tunnel name: Customizes the name of the tunnel, which must not
repeat with the existing instance name in the device.
User type: The options include LAN to LAN, mobile users.

LAN to LAN: An incoming PPTP user is the user of a network segment, which often is
dialed through via a router, to implement communications in the LAN at both ends of
the PPTP tunnel.

Mobile user: The dialed-in VPN user is an individual user, which is often dialed in by a
http://www.level1.com
Figure 12_4 PPTP server - Account Settings
Chapter 12 VPN
Page 125