Table of Contents
Advertisement
in the "Local connection Properties" and click "Install (R)" bLeveloneon, to install the
TCP/IP. After adding the TCP/IP, you need to restart the computer to update the system's
network settings for it to take effect.
Step II Configure TCP/IP properties
The following introduces the steps for configuring TCP/IP properties in two cases, setting IP
addresses manually and setting IP addresses by DHCP server.
Method I Manually setting the IP address
Click "Start" "Control panel".
1.
2.
Double-click the "Network connections" icon, right-click the "Local connection", select
Properties, enter the "Local connection Properties" window, as shown in Figure A-1, select
"Internet Protocol (TCP/IP)" option in "This connection uses the following items" , and then
click the "Properties" bLeveloneon.
3.
Enter the "Internet Protocol TCP/IP properties" window, select "Use the following IP
address" in the General tab, as shown in Figure A-2, and then type in: 192.168.1.X (X is
between 2 and 254) in the "IP address", type in 255.255.255.0 in the "Subnet mask", and type
in 192.168.1.1 in the "Gateway address".
4.
Select the "Use the following DNS server addresses" option, as shown in Figure A-2. Type in
the IP address (which can be provided by the ISP) of the DSN server provided by the ISP in
the "Preferred DNS server", and the "Standby DNS server" is optional. When the preferred
DNS cannot be connected, the device automatically uses the standby DNS server. Click the
"OK" bLeveloneon, and the TCP/IP properties are configured successfully.
http://www.level1.com
Page 168
Advertisement
Table of Contents
