Remote Control; Mig Extra Functions - Kemppi Kempact Pulse 3000 Operating Manual

3.3.7 remote control

Gun control, wire feed speed or welding power control is changed using RMT 10. Control of
the welding voltage or the length of the welding arc can be adjusted using the potentiometer
on the panel. Panel control, adjustments using the potentiometer on the panel.

3.3.8 mig extra functions

Crater filling, 1-MIG and pulse MIG:
Crater filling reduces welding mistakes caused by end craters. By pressing the 4T-trigger
continuously at the end of weld, a descending welding power is achieved which fills end
craters in a controlled manner. The descending time is kept constant using the 2T function,
and the welding power and end level can be changed using the SETUP-function.
Wire range/
power/Welding
current
Start switch 4T
the hot start:
The Hot Start function is used with 1-MIG and pulse MIG welding. The Hot Start time by 4T
Hot Start time is determined by trigger function (see picture) and while by 2T function it
is determined by the SETUP parameters. The level of Hot Start can be changed by SETUP
function.
The Hot Start level, Hot Start time by 2T, crater fill level and downslope time can be easily
adjusted using the 'QUICK SETUP' function:
1. Select the gun trigger function: 4T or 2T.
2. First, press the SETUP button and then , while still pressing the SETUP button, press the
extra function button.
3. Adjust the Hot Start level.
4. Repeat step 2, upon which the display will show the next adjustable parameter,
depending on the switch mode.
Exit by pressing any button (except SETUP)
© Kemppi Oy / 1336
Crater filling
Hot Start
EN
15