Installation Of Welding Gun; Mounting And Locking Of Wire Reel - Kemppi Kempact Pulse 3000 Operating Manual

Al, (Fc, Mc, Ss, Fe)
U-groove
Wire feed rolls, metal
Fe, Ss,
(Al, Mc, Fc)
V-groove
Fc, Mc, (Fe)
V-groove, knurled
Al, (Fc, Mc, Ss, Fe)
EN
U-groove
Mount the lower feed roll, ensuring that the pin on the shaft fits in the cut on the feed roll.
NOTE!
2.8

installation of welding gun

Make sure the gun wire conduit and the contact tip match the manufacturer's
recommendations for the type and diameter of wire you use. Too small a conduit may
overload the wire feed device and impede the wire feeding. Tighten the gun's quick connector
to eliminate voltage loss. A loose joint will heat up the gun and wire heater.
Never use defected gun.
NOTE!
2.9

mounting and locking of wire reel

LOCKED
• Release locking nails of wire reel hub by turning locking knob a quarter round.
• Mount the reel at its place. Note rotating direction of reel!
• Lock the reel with locking knob, locking nails of hub remain to outside position and will
lock the reel.
6
Kempact Pulse 3000, KempactCool 10
1.0 red
1.2 orange
1.6 yellow
ø mm
0.8 – 0.9
1.0
1.2
1.4
1.0
1.2
1.4 – 1.6
2.0
1.0
1.2
1.6
OPEN
W001067 W001068
W001069 W001070
W001071 W001072
lower upper
W006074 W006075
W006076 W006077
W004754 W004753
W006078 W006079
W006080 W006081
W006082 W006083
W006084 W006085
W006086 W006087
W006088 W006089
W006090 W006091
W006092 W006093