LifeSpan rower 305 Owner's Manual page 7

STEP 2:
1. Turn the Centre Beam Assembly to the normal upright position.
2. Insert the Bracket on FRONT STABILIZER (2) into the FRONT SUPPORT (29) and secure with
BUTTON HEAD BOLTS (M8x1.25x15mm) (14) and WASHERS (M8) (16). Do not tighten the
bolts until Step 4.
STEP 3:
NOTE: During this step it is important that you hold the HANDLEBAR (9) while you are cutting the
Cable Tie. For packing, a section of the ROPE (51) that is attached to the HANDLEBAR (9) is pulled
out of the UPRIGHT (3). The ROPE (51) has a spring force that will snap the HANDLEBAR (9) to the
UPRIGHT (3) after cutting off the Cable Tie.
1. Hold the HANDLEBAR (9) and cut off the Cable Tie which ties the HANDLEBAR (9) to the
UPRIGHT (3).
2. Swing the UPRIGHT (3) up and place the HANDLEBAR (9) on the HANDLEBAR HOLDER
(50).
ROWER 305
7