LifeSpan rower 305 Owner's Manual page 15

Rope Adjustment
Over time your ROPE (51) may stretch. If the ROPE (51) doesn't retract fully into the UPRIGHT (3) and
the HANDLEBAR (9) doesn't stay on the HANDLEBAR HOLDER (50), make this adjustment. Remove
the HANDLEBAR COVER (52) by unscrewing the SCREWS (M4x15mm) (49). Loosen the BOLTS
(M6x1x20mm) (64), but do not remove them. Pull the ROPE (51) until there is a 3/8 inch of gap on the
shaft of the SHOCK (42), refer to illustration A. Then entwine the ROPE (51) around the BOLTS
(M6x1x20mm) (64) using a figure eight pattern and tighten the bolts so the ARC WASHERS (M6) (65)
press against and secure the ROPE (51) in position. Re-attach the HANDLEBAR COVER (52) with the
SCREWS (M4x15mm) (49).
15
ROWER 305