Floppy Drive Connector (Fdd1); Parallel Port (Lpt1) - Advantech PCA-6013 User Manual

Hide thumbs Also See for PCA-6013:

Table of Contents

2.3

Floppy Drive Connector (FDD1)

You can attach one floppy disk drives to the PCA-6013's on board controller. You can

use 3.5" (720 KB, or 1.44 MB) drives.

The single board computer comes with a 34-pin daisy-chain drive connector cable.

On one end of the cable is a 34-pin flat-cable connector. On the other end are two

sets of 34-pin flat-cable connector (usually used for 3.5" drives). The set on the end

(after the twist in the cable) connects to the A: floppy drive.

2.4

The parallel port is normally used to connect the single board computer to a printer.

The PCA-6013 includes an onboard parallel port, accessed through a 26-pin flat-

cable connector, LPT1. The card comes with an adapter cable which lets you use a

traditional DB-25 connector. The cable has a 26-pin connector on one end and a DB-

25 connector on the other, mounted on a retaining bracket. The bracket installs at the

end of an empty slot in your chassis, giving you access to the connector.

Figure 2.2 FDD Connector (FDD1)

Figure 2.3 LPT Connector (LPT1)

FDD1

LPT1

PCA-6013 User Manual

Table of Contents