Table of Contents
Advertisement
1.10
Memory Installation Procedures
1.
See picture below to locate DIMM1 and DIMM2 204-pin SODIMM sockets.
2.
A memory module and expansion socket are keyed. The plastic bridge in the
socket must align with the notch in the module. The keyed bridge and notch
make sure a SODIMM cannot be installed going the wrong direction.
3.
Insert the SODIMM module into the socket at a 30-45 degree angle. Make sure
the notch and the module are properly aligned.
Slowly push down the SODIMM toward the CPU card PCB until the clips at each
end of the expansion socket click into place.
1.11
Processor Installation
PCA-6013 series are equipped with soldered-down (BGA type) CPUs. No need for a
user to install a CPU.
9
PCA-6013 User Manual
Advertisement
Table of Contents
