Table of Contents
Advertisement
3
Installing Rear Weights
Parts needed for this procedure:
Varies
Rear weights (quantity varies with configuration).
Procedure
The Groundsmaster 4300–D Traction Unit complies with EN ISO 5395:2013 and ANSI B71.4-2012 standards when equipped
with rear weights and/or 40.8 kg (90 lb) of calcium chloride ballast is added to rear wheels. Use the following charts to
determine the combinations of weights required for your configuration. Order parts from your Toro Distributor.
Number of weights
Configuration
to meet ANSI (US)
Base Unit
With Recycler
40.8 kg (90 lb) calcium
Kit
With
40.8 kg (90 lb) calcium
Sunshade
With 4 Post
40.8 kg (90 lb) calcium
ROPS &
Sunshade
* Install tubes inside the rear tires before adding calcium chloride.
Important: Always install tubes inside the rear tires before calcium chloride is installed. If a puncture occurs in a
tire with calcium chloride, remove the machine from the turf area as quickly as possible. To prevent possible damage
to the turf, immediately soak the affected area with water.
Number of weights to
meet CE (European)
standards
6
chloride*
chloride*
chloride*
Weight P/N 110-8985-03
Fasteners (2 each
required) for weights
standards
3231–34 Carriage Bolt
0
0
3231–7 Carriage Bolt
4
3231–7 Carriage Bolt
4
Figure 3
11
3 on top of bumper and
104–8301 Nut
N/A
1 on top of bumper and
104–8301 Nut
1 on top of bumper and
104–8301 Nut
Weight Location
3 under bumper
N/A
3 under bumper
3 under bumper
Advertisement
Table of Contents
