Table of Contents
Advertisement
Protected Menus
There is 1 operating configuration setting that is adjustable
within the Settings Menu of the InfoCenter: counterbalance.
This setting can be locked by using the Protected Menu.
Note: At the time of delivery, the initial password code is
programmed by your distributor.
Accessing the Protected Menu Settings
1. From the Main Menu, scroll down to the Settings
Menu and press the right button.
2. In the Settings Menu, scroll down to the Protected
Menu and press the right button.
3. To enter the passcode, use the center button to set the
first digit and then press the right button to move on
to the next digit.
4. Use the center button to set the second digit and then
press the right button to move on the next digit.
5. Use the center button to set the third digit and then
press the right button to move on to the next digit.
6. Use the center button to set the fourth digit and then
press the right button.
7. Press the middle button to enter the code.
8. If the code has been accepted and the protected menu
has been unlocked, "PIN" will be displayed in the
upper right corner of the display screen.
Note: If you forget or misplace your passcode, contact
your Toro Distributor for assistance.
Viewing and Changing the Protected
Menu Settings
1. In the Protected Menu, scroll down to Protect Settings.
2. To view and change the settings without entering a
passcode, use the right button to change the Protect
Settings to O
.
FF
3. To view and change the settings with a passcode, use
the left button to change the Protect Settings to O
set the passcode, and turn the key in the ignition switch
to the O
position and then to the O
FF
Setting the Counterbalance
1. In the Settings Menu, scroll down to Counterbalance.
2. Press the right button to select counterbalance and
change between the low, medium, and high settings.
Specifications
Note: Specifications and design are subject to change
without notice.
Transport Width
Width of cut
Length
Height
Net weight*
Fuel tank capacity
Transport speed
Mowing speed
* With cutting decks and fluids
Cutting Deck
Length
Width
Height
Weight
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro genuine
parts. When it comes to reliability, Toro delivers replacement
parts designed to the exact engineering specification of our
equipment. For peace of mind, insist on Toro genuine parts.
,
N
position.
N
19
226 cm (89 inches)
229 cm (90 inches)
320 cm (126 inches)
218 cm (86 inches)
1,412 kg (3,114 lb)
53 L (14 US gallons)
0 to 16 km/h (0 to 10 mph)
0 to 13 km/h (0 to 8 mph)
86.4 cm (34 inches)
86.4 cm (34 inches)
24.4 cm (9.6 inches)
to carrier mount
26.7 cm (10–1/2 inches)
at 3/4 inch height of cut
34.9 cm (13–3/4 inches) at
4 inch height of cut
88 kg (195 lb)
Advertisement
Table of Contents
