Table of Contents
Advertisement
6
Adjusting the Carrier Frame
No Parts Required
Adjusting the Front Cutting Decks
The front and rear cutting decks require different mounting
positions. The front cutting deck has 2 mounting positions
depending on what height of cut and degree of deck rotation
you desire.
1. For heights of cut between 2.0 to 7.6 cm (0.75 to 3
inches), mount the front carrier frames in the lower
front mounting holes
Note: This permits more up travel of the cutting
decks relative to tractor when approaching quick uphill
changes in terrain. It does however limit the clearance
of the chamber to the carrier when cresting sharp
knolls.
1. Front deck mounting hole
(upper)
2. Front deck mounting hole
(lower)
2. For heights of cut between 6.3 to 10 cm (2.5 to 4
inches), mount the front carrier frames in the upper
front mounting holes
Note: This increases the chamber to carrier clearance
due to the higher position of the cutting chamber, but
will cause the cutting decks to reach their maximum
up travel sooner.
(Figure
7).
Figure 7
3. Rear deck mounting hole
(Figure
7).
Adjusting the Rear Cutting Deck
The front and rear cutting decks require different mounting
positions. The rear cutting deck has 1 mounting position for
proper alignment with the sidewinder under frame.
For all heights of cut, mount the rear cutting deck in the
rear-mounting holes
(Figure
7
Adjusting the Roller Scraper
(Optional)
No Parts Required
Procedure
The optional rear roller scraper is designed to work best when
there is an even gap of 0.5 to 1 mm (0.020 to 0.040 inch)
between the scraper and roller.
1. Loosen the grease fitting and the mounting screw
(Figure
8).
1. Roller scraper
2. Mounting screw
2. Slide the scraper up or down until a gap of 0.5 to 1
mm (0.020 to 0.040 inch) is achieved between the rod
and the roller.
3. Secure the grease fitting and torque to 41 N∙m (30 ft-lb)
in an alternating sequence.
13
7).
1
2
3
Figure 8
3. Grease fitting
G011346
Advertisement
Table of Contents
