Adjusting The Control Arm Position; Removing The Shipping Blocks And Pins - Toro 30853 Operator's Manual

1
Adjusting the Control Arm
Position
No Parts Required
Procedure
The control arm position can be adjusted for the operator's
comfort.
1. Loosen the 2 bolts securing the control arm to the
retaining bracket (Figure
1. Control arm
2. Retaining brackets
2. Rotate the control arm to the desired position and
tighten the 2 bolts.
2).
Figure 2
3. Bolts (2)
2
Removing the Shipping Blocks
and Pins
No Parts Required
Procedure
1. Remove and discard the shipping blocks from the
cutting decks.
2. Remove and discard the shipping pins from the
cutting-deck suspension arms.
Important: The shipping pins stabilize the cutting
decks during shipping, remove them before operation.
10