Installing Rear Weights - Toro 30859 Operator's Manual

5

Installing Rear Weights

Parts needed for this procedure:
Varies Rear weights (quantity varies with configuration).
Procedure
The Groundsmaster 4300–D Traction Unit complies with CEN standard EN 836:1997, ISO standard 5395:1990, and ANSI
B71.4-2004 Standards when equipped with rear weights and/or 90 lb of calcium chloride ballast is added to rear wheels. Use
the following charts to determine the combinations of weights required for your configuration. Order parts from your
local Authorized Toro Distributor.
Number of weights to
Configuration
meet ANSI (US) standards
Base Unit
With Recycler
90 lb calcium chloride*
Kit
With Sunshade
90 lb calcium chloride*
or Cooltops
With 4 Post
ROPS &
90 lb calcium chloride*
Sunshade or
Cooltops
* Install tubes inside the rear tires before adding calcium chloride.
Important: Always install tubes inside the rear tires before calcium chloride is installed. If a puncture occurs in a
tire with calcium chloride, remove the machine from the turf area as quickly as possible. To prevent possible damage
to the turf, immediately soak the affected area with water.
Use the following procedure to mount the appropriate amount of weight (see weight charts) to the top or bottom of the
rear bumper as shown in Figure 4.
Number of weights to
meet CE (European)
standards
6
Weight P/N 110-8985-03
Fasteners (2 each
required) for weights
3231–34 Carriage Bolt
0
104–8301 Nut
0
3231–7 Carriage
4
Bolt104–8301 Nut
3231–7 Carriage
4
Bolt104–8301 Nut
13
Weight Location
3 on top of bumper and
3 under bumper
N/A
1 on top of bumper and
3 under bumper
1 on top of bumper and
3 under bumper
N/A