Raising the Machine
Note: Use jack stands to support the machine when required.
Use the following as points to jack up the machine:
•
Front of the machine—rectangular pad, under the axle
tube, inside each front tire
Figure 28
1. Front jacking point
•
Rear of the machine—rectangular axle tube on the rear
axle.
(Figure
28).
Lubrication
Greasing the Bearings and
Bushings
If you operate the machine under normal conditions, lubricate
all grease fittings for the bearings and bushings after every
50 hours of operation with No. 2 lithium grease. Lubricate
bearings and bushings immediately after every washing,
regardless of the interval listed.
The grease fitting locations and quantities are as follows:
•
Pump driveshaft U-joint (3)
•
Cutting unit lift-arm cylinders (2 each)
•
Lift-arm pivots (1 each)
35
(Figure
29)
Figure 29
(Figure
30)
Figure 30
(Figure
30)