Removing The Shipping Blocks And Pins; Installing The Rear Weights - Toro Groundsmaster 4300-D Operator's Manual

3
Removing the Shipping
Blocks and Pins
No Parts Required
Procedure
1. Remove and discard the shipping blocks from
the cutting units.
4

Installing the Rear Weights

For ANSI or CE Compliance
Parts needed for this procedure:
Varies Rear weights (quantity varies with configuration).
Procedure
The Groundsmaster 4300-D Traction Unit complies with EN ISO 5395 and ANSI B71.4-2017 standards when
equipped with rear weights and/or 40.8 kg (90 lb) of calcium chloride ballast that is added to the rear wheels.
Use the following charts to determine the combinations of weights required for your configuration. Contact your
authorized Toro distributor for the appropriate parts needed for your machine.
Number of weights
Configuration to meet ANSI (US)
Base Unit
With Recycler 40.8 kg (90 lb) calcium
Kit
With 40.8 kg (90 lb) calcium
Sunshade
With 4 Post
40.8 kg (90 lb) calcium
ROPS and
Sunshade
* Install tubes inside the rear tires before adding calcium chloride.
Important:
Always install the tubes inside the rear tires before you add the calcium chloride. If a
puncture occurs in a tire with calcium chloride, remove the machine from the turf area as quickly as
possible. To prevent possible damage to the turf, immediately soak the affected area with water.
Weight Part Number: 110-8985-03
Number of weights to
meet CE (European)
standards
6
chloride*
chloride*
chloride*
2. Remove and discard the shipping pins from the
cutting-unit suspension arms.
Note:
units during shipping; remove them before
operating the machine.
Fasteners (2 each
required) for weights
standards
Carriage bolt (3231-34)
0
Nut (104-8301)
0
Carriage bolt (3231-34)
4
Nut (104-8301)
Carriage bolt (3231-34)
4
Nut (104-8301)
12
The shipping pins stabilize the cutting
Weight Location
3 on top of bumper and
3 under bumper
N/A
1 on top of bumper and
3 under bumper
1 on top of bumper and
3 under bumper
N/A