Dell 2155cn User Manual page 724

admin\Desktop\0630_UG??\Mioga_AIO_UG_FM\Mioga_AIO_UG_FM\section31.fm
There are lines on the
documents you send.
The printer dials a number,
but the connection with
another fax machine fails.
Documents are not stored in
the memory.
Blank areas appear at the
bottom of each page or on
other pages, with a small strip
of text at the top.
The printer will not send or
receive faxes.
An error often occurs during a
fax transmission or reception.
The printer receive faxes, but
it does not print.
D E L L C O N F I D E N T I A L – P R E L I M I N A RY 9 / 1 3 / 1 0 - F O R P R O O F O N LY
722
Troubleshooting Guide
Downloaded from ManualsPrinter.com Manuals
FILE LOCATION: C:\Users\fxstdpc-
Check your scan glass for marks and clean it. See
"Cleaning the Scanner."
The other fax machine may be turned off, out of paper,
or cannot answer incoming calls. Speak with the other
machine operator and ask her/him to sort out the
problem.
There may not be enough memory to store the
document. If the display shows a Memory Full
message, delete any documents you no longer need from
the memory and then restore the document, or wait for
the job in progress (e.g., a fax transmission or reception)
to complete.
You may have chosen the wrong paper settings in the
user option setting. See "Print Media Guidelines."
Ensure that the country code is set correctly. Press the
(Menu) button and select System Setup Admin
Menu Fax Settings Country.
Check the dialing type for Tone or Pulse.
Check that the cables are connected properly.
If the telephone line cord is connected to the printer via
any device such as an answering machine and a
computer, remove the device and directly connect the
telephone line cord to the printer.
Reduce the modem speed. the
select System Setup Admin Menu Fax
Settings Modem Speed.
Check the toner level.
Ensure that there is paper in the paper tray.
Ensure that Sent Fax Fwd is set to off.
Ensure that Junk Fax Setup is set to off.
Ensure that Secure Receive Set is set to disabled.
Execute Reset Defaults.
(Menu) button and