Dell 2155cn User Manual page 491

HTTP-SSL/TLS
IP Filter
NOTE:
Purpose:
To block data received from certain IP addresses through the wired or wireless
network. You can set up to five IP addresses. The change becomes effective
after the printer is turned off and then on again.
Values:
No. n / Address (n is 1–5.)
No. n / Mask (n is 1–5.)
No. n / Mode (n is 1–5.) Off
IEEE 802.1x
NOTE:
LAN cable and it is available only when the IEEE 802.1 authentication is enabled.
Purpose:
To disable IEEE 802.1x authentication. The change becomes effective after the
printer is turned off and then on again.
Values:
Disable Disables IEEE 802.1x.
Reset LAN
Purpose:
To initialize wired network data stored in non-volatile memory (NVM). After
executing this function and rebooting the printer, all wired network settings are
reset to their default values.
Values:
Downloaded from ManualsPrinter.com Manuals
Disable Disables HTTP-SSL/TLS.
*
Enable Enables HTTP-SSL/TLS.
IP Filter feature is available only for
*
Accept Accepts an access from the specified IP address.
Reject Rejects an access from the specified IP address.
IEEE 802.1x feature is available only when the printer is connected using
LPD
Sets the IP address for Filter n.
Sets the address mask for Filter n.
Disables the IP Filter feature for Filter n.
Understanding the Printer Menus
Port9100
or .
489