Preset - Honeywell ScanDome II HSDN-251NS/PS Operation & Programming Manual

3. Twist the Joystick to enter the title by scrolling through the alphanumeric characters and
pushing the handle to the right or left to move to the next space. Press Enter key or push the
Joystick down to finish title mode
4. Push the handle downward to select "SPEED' and set the speed by moving the Joystick left
and right to select the auto scan speed.
5. When finish entering the speed, select "START ANGLE' with the Joystick. Hold down the
Ctrl/PGM key while selecting the start position using the Joystick. Current panning position
will be displayed. Release Ctrl/PGM key to complete the selection of the start position.
6. Push the Joystick downward to select "END ANGLE.' Hold down the Ctrl/PGM key while
moving the joystick to select the end position. The end position angle should be larger than
start position. Release the Ctrl/PGM key to complete the selection of the end position.
7. Push the Joystick downward to select "SCAN DIR' and set the scan direction by moving the
Joystick left and right to select the auto scan direction.(CW or CCW)
8. Push the Joystick downward to select "SWAP' and set the swap by moving the Joystick left
and right to select the swap ON or OFF.
9. Select Save and Exit by pushing the Joystick to the right. Press ESC to exit the program
without saving.
Pressing the Home key causes the camera to go to the 000.0 angle immediately.
NOTE: Using the Tour mode in conjunction with preset and Auto Scan, you can make the camera
travel from one preset position to another preset position at a specific speed. (Pan only)
a. Before entering the Auto Scan menu, select a preset position as a starting point for Auto Scan.
Example: 2 + Prst and do step 1 to 4. Instead of step 5, just press the Ctrl/PGM key at the start
angle position, the current position will be displayed as a start position.
b. Save and exit from the menu.
c. In normal mode, call a preset to be the end point of scan. Press 3 + Prst then press Scan
key to enter the Auto Scan menu. Move the cursor position to END ANGLE. Just press
Ctrl/PGM key at the end angle position. Do step 7 to 9.
Example: Preset 001>002>003>004>005>006, Auto Scan 01 starts at 002, ends at 003,
Auto Scan 02 starts at 005, ends at 006. Tour 001, 002, A01, 004, A02.
1 è 2 2~3 è 4 è 5~6 è1 è 2 2~3 " "
è : Quick move, ~ : Programmed speed by Auto Scan.
Where

3.5 Preset

(Second Item of the Main menu / Shortcut: Prst)
12