Honeywell ScanDome II HSDN-251NS/PS Operation & Programming Manual page 32

The offset value is still valid after all data is erased. The offset value can be zero only with
default set of Offset origin menu.
CAUTION: All the data in the selected dome camera will be lost unless you download the
data into a safe place. (Refer to Download/ Upload data function in Keyboard
Configuration utility.) Data from the selected dome camera can be stored in the
keyboard controller temporarily. If you want to save the data of all installed
dome cameras, you need a special I/O interface and software for PC.
㿱ORIGIN OFFSET
This feature is useful to align a new dome camera exactly the same as the previously installed
dome camera.
Dome camera█s origin set and all data initialize option do not override offset values. Only the
default set option in this menu will set the offset value to zero. This can be used to avoid ceiling
obstructions.
㿱DOME RESET
This feature is used to re-calibrate the orientation of a selected dome camera. Origin offset value
is not affected by this function. (Offset is still valid after origin set)
㿱SYSTEM INFORMATION
A Dome camera█s Setup menu provides essential information about the dome camera if service
is required. When you view this screen, you can determine the camera type, ROM version.
The information on this screen cannot be modified.
OFFSET SETUP
PAN OFFSET
TITLT OFFSET
ENABLE
SAVE AND EXIT(ESC TO CANCEL)
SYSTEM INFORMATION
CAMERA TYPE : XXXXXXX
H/W VERSION
ROM VERSION : V1.0
PROTOCOL
BUADRATE
EXIT(ESC TO EXIT)
: 000.0
: 00.0
: OFF
: V1.0
: SCANDOME II
: 9600BPS
26