Alarm; Area Title - Honeywell ScanDome II HSDN-251NS/PS Operation & Programming Manual

NOTE: If total recording time reaches 240 seconds, it will automatically stop for a moment and
restart recording. Previous data will be overwritten.

3.9 Alarm

(This menu shows on only specific model, Fifth Item of Main menu)
NO : Alarm input number
PRIO : Lower No. has higher priority, Equal priority alarms will be serviced repeatedly.
PRS : Stored preset number to be called by alarm.
IN : NO/NC - normally open /Closed OFF - ignore
OUT : OUT1~OUT4 - Relay out 1,2,3,4, OFF - No output.
HOLD : Alarm will be held for programmed time (01 to 99 seconds)
LATCH : ON - Shows all alarms including past alarm, OFF - Shows activated alarms only.
There is one "0' PRIO which is a first priority. "0' priority can choose Autoscan, Pattern or Tour.
When responding "0' priority alarm, there is no respond other alarm until finishing "0' priority
action
1. Press Menu to display the main menu on the monitor. Select the Alarm option by pushing
the Joystick up or down and push to right to enter the detail menu.
2. Select the alarm input number by pushing the joystick up or down and select the column
you wish to setup. Selected position will be highlighted.
3. Select the Preset, Status of Input (NC/NO/OFF), and Output (OUT1~4/OFF) by pushing the
joystick to the right or to the left.
4. To increase or decrease the preset number or to change the status or output number, twist
the joystick clockwise or counterclockwise. In case of preset, programmed preset number
will be scrolled.
5. Select the Save and Exit option by pushing the joystick up or down. Save and exit the
program by pushing the joystick to the right. Press ESC to exit the program without saving.

3.10 Area Title

(Sixth Item of Main menu)
Enter a specific name on programmed angle between START and END. For the screen below,
when the camera points at an angle between 124.3° to 359.5°, ABC will be displayed on the
screen.
ALARM SETUP
NO PRI PRS IN
01 1 001 OFF OFF
02 8 001 OFF OUT1
03 1 240 NO
04 2 001 NC
05 1 001 OFF OFF
06 8 001 OFF OUT1
07 1 240 NO
08 2 001 NC
SAVE AND EXIT ( ESC TO CANCEL)
OUT HLD LATCH
03 OFF
03 OFF
OUT1 03 OFF
OUT4 03 OFF
03 OFF
03 OFF
OUT1 03 OFF
OUT4 03 OFF
17