Table of Contents
Advertisement
2.5 BLUETOOTH INSTALLATION
In the bar code collector with Bluetooth interface some settings can be made in the system menu.
Get system menu
Cancel operation
2.5.1 SET OR SEARCH BLUETOOTH DEVICE ADDRESS:
To enable the bar code data collector with Bluetooth interface to communicate to another Bluetooth device,
the Bluetooth address of the device needs to be set in the system menu of the bar code data collector.
18 - OPTICON OPL972X/CRD972X
Press all 3 keys at the same time to get the system menu.
To navigate downwards use the right key [Q2] and to navigate
upwards use the left key [Q1]. Confirm or select with the middle
[Trigger]key.
When an operation needs to be cancelled, press all 3 keys at the
same time to cancel the current option and get the system menu.
Start the system menu
Select option Input address.
Set Bluetooth address
To set by manual entry, select Manual.
To search for Bluetooth device address, select Discovery.
Manual entry
The address shown is either 000000000000, or the address that
was entered before.
The Bluetooth address can be found on the other device. Mostly it
is displayed on the product label as a 12 digits number or a number
with 6 hex digit pairs. (e.g. 0050f27d78c5).
The digits can be selected one by one by the block marker.
Change the digit by pressing the left key [Q1]. Every time the left
key [Q1] is pressed the value of the digit is incremented by one
hexadecimal value. When the proper value is displayed move the
marker to the next digit with the right key [Q2].
When the setting of the device address is done, confirm with the
middle [Trigger]key.
Advertisement
Table of Contents
