Table of Contents
Advertisement
2.3.3 CONNECT RS232 MULTICRADLE
Start
Switch off the power of the host computer.
(ref. 1.) Choose proper place
Place the multicradle in normal office conditions,
avoid a place under strong light.
(ref. 2.) Set DIP switch
Set the required DIP switches for baud rate. For
(default) settings notice DIP switch table in the next
chapter.
(ref 3.) Connect interface cable
Connect the cable between the multicradle and the
host computer.
For RS232 interface use the left RS232 connector
(RS232C-1).
(ref. 4.) Connect power
Connect the power supply.
End
Switch on the power of the host computer.
Place the bar code data collector(s) in the
multicradle.
LED indicator
Typical LED indications are:
red: power is on
flashing green: collector sends to host
flashing yellow: host sends to collector
FOR CONNECTING A NETWORK OF
MULTICRADLES SEE RS485 DESCRIPTION.
14 - OPTICON OPL972X/CRD972X
1
2
6
5
4
3
2
1
ON
3
4
Advertisement
Table of Contents
