4.7
OS/2 Drivers Setup Procedure
Preliminary steps
The following steps must be performed before you install the SIS5598
display driver:
1. OS/2 DOS Support must be installed.
2. If you previously installed SVGA support, you must reset the
system to VGA mode. VGA is the default video mode enabled
when OS/2 is installed.
To restoreVGA mode, use Selective Install and select VGA for
Primary Display. For more information on this procedure, see the
section on Changing Display Adapter Support in the OS/2 User's
Guide.
Installing from diskette
To install this driver:
1. Open an OS/2 full screen or windowed session.
2. Place the SIS5598 Display Driver diskette in Drive A.
3. At the OS/2 command prompt, type the following commands to
copy the files to the OS/2 drive:
A:
SETUP A:
where
When the setup program is completed, you will need to perform a
shutdown and then restart the system in order for changes to take
effect.
A log of the information output during the install can be found in
<root>:\OS2\INSTALL\DISPLAY.LOG
PCA-6155V User's Manual
46
<ENTER> to make this the default drive.
C:
A: is the floppy disk drive, and
C: is the hard disk partition containing \OS2
<ENTER>