Controls - Toro 41582 Operator's Manual

Controls

1. Steering wheel
2. Master boom foot switch
3. Pressure gauge
Traction Pedal
The traction pedal (Figure 7) controls the movement of
the machine, both forward and reverse. Using the heel
and toe of the right foot, press the top of the pedal to
move forward or the bottom of the pedal to move in
reverse. Release the pedal to slow and stop.
1. Traction pedal
2. Brake pedal
Important: Ensure that you allow the sprayer
to come to a stop before switching between the
Forward and Reverse position.
Note: The farther you press the pedal in either
direction, the faster the sprayer will travel. To obtain
maximum forward speed, set the throttle lever to the
1
2
4. Dash controls
5. Traction pedal
6. Sprayer controls
Figure 7
3. Parking brake pedal
4. Master boom switch
3
4
9
8
Figure 6
Fast position and press the traction pedal all the way
forward.
Note: To obtain maximum power with a full tank or
when traveling up a hill, set the throttle lever in the Fast
position and drive slowly so that the engine remains at
a high rpm.
Brake Pedal
Use the brake pedal to stop or slow the sprayer
(Figure 7).
If you operate the sprayer with poorly adjusted
or worn brakes, you could lose control of the
sprayer, resulting in serious injury or death to
you or bystanders.
Always check the brakes before operating the
sprayer and keep them properly adjusted and
repaired.
Parking Brake
The parking brake is a pedal to the left of the brake
(Figure 7). Engage the parking brake whenever you
plan on leaving the seat to prevent the sprayer from
accidently moving. To engage the parking brake, press
the brake pedal and, while holding the brake, press the
parking brake pedal. To disengage, press and release the
15
5
7
6
G002199
7. Throttle lever
8. Operator's position
9. Passenger position