Toro 41582 Operator's Manual page 18

Foam Marker Switch Locations
(Optional)
If you install the electric boom lift, sonic boom, and
foam marker kit, you will add switches to the control
panel for controlling their operation. The sprayer comes
with plastic plugs in these locations.
Agitation Switch
The agitation switch is located on the control panel to
the right of the seat (Figure 13). Toggle this switch
forward to turn on the agitation in the tank or rearward
to stop the agitation. When the switch is turned on, a
light on the switch illuminates. For agitation to work,
the pump must be on and the engine must be running
above an idle. The agitation valve is located behind the
tank (Figure 14)
Figure 14
1. Agitation valve
Boom Valves
These valves turn the three booms on or off (Figure 14).
If you ever need to manually turn off a boom, rotate
the knob on the valve clockwise to turn the valve off or
counterclockwise to turn it on.
Boom Bypass Valves
The boom bypass valves redirect the fluid flow for a
boom to the tank when you turn off the boom section.
They are located at the bottom of each boom valve
section. You can adjust these valves to ensure that the
boom pressure remains constant no matter how many
booms are on. Refer to Calibrating the Boom Bypass
Valves in the Operation section.
Note: If you use the Pro Control, you must shut all
the bypass valves.
2. Boom valves
Anti-siphon Fill Receptacle
To the front of the tank cover is a hose receptacle with a
threaded fitting, a 90 degree barbed fitting, and a short
hose which you can direct toward the tank opening. This
receptacle allows you to connect a water hose to it and
fill the tank with water without contaminating the hose
with the chemicals in the tank.
Important: Do not lengthen the hose to allow
contact with the tank fluids.
G002204
1. Anti-siphon fill receptacle
Tank Cover
The tank cover is located in the center of the top of the
tank. To open it, turn off the engine, then turn the front
half of the cover to the left and swing it open. You can
remove the strainer inside for cleaning. To seal the tank,
close the cover and rotate the front half toward the right.
18
1
Figure 15