Fuel System Maintenance; Servicing The Fuel Tank; Checking The Fuel Line And Connections; Bleeding The Fuel System - Toro 41582 Operator's Manual

Turf sprayer
Hide thumbs Also See for 41582:
Table of Contents

Advertisement

10. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn (Figure 42).
Note: Do not over tighten the filter.
11. When the oil has drained completely, replace the
drain plug and torque it to 10 ft-lb (13.6 N⋅m).
12. Dispose of the used oil at a certified recycling center.
13. Remove the oil filler cap and slowly pour
approximately 80% of the specified amount of oil
into the engine at the oil filler (Figure 39).
14. Check the oil level.
15. Slowly add additional oil to bring the oil level to the
full mark on the dipstick.
Important: Overfilling the crankcase with oil
may cause engine damage.
16. Replace the oil filler cap.
Fuel System
Maintenance

Servicing the Fuel Tank

Service Interval: Every 400 hours
Yearly
Drain and clean the fuel tank if the fuel system becomes
contaminated or if you plan to store the machine for an
extended period. Use clean fuel to flush out the tank.
Under certain conditions, diesel fuel and fuel
vapors are highly flammable and explosive. A
fire or explosion from fuel can burn you and
others and can cause property damage.
• Use a funnel and fill the tank outdoors, in
an open area, when the engine is off and is
cold. Wipe up any fuel that spills.
• Do not fill the fuel tank completely full. Add
fuel to the fuel tank until the level is 1 inch
(25 mm) below the bottom of the filler neck.
This empty space in the tank allows the fuel
to expand.
• Never smoke when handling fuel, and stay
away from an open flame or where fuel
fumes may be ignited by a spark.
• Store fuel in a clean, safety-approved fuel
container and keep the cap in place.
Checking the Fuel Line and
Connections
Service Interval: Every 50 hours
Every 400 hours
Yearly
Check the fuel lines and connections every 400 hours
or yearly, whichever comes first. Inspect the lines
and connections for deterioration, damage, or loose
connections.

Bleeding the Fuel System

1. Park the machine on a level surface.
2. Ensure that the fuel tank is at least half full.
37

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multi-pro 5700-d

Table of Contents