Toro 41582 Operator's Manual page 17

Figure 11
1. Fuel gauge
Master Boom Switch
The master boom switch is located on the floor board
of the machine cab and to the left of the operator. It
allows you to start or stop the spray operation. Press
the switch with your foot to enable or disable the spray
system (Figure 12).
Figure 12
1. Master boom switch
Boom Switches
The boom switches are located on the control panel to
the right of the seat (Figure 13). Toggle each switch
forward to turn the corresponding boom section on and
rearward to turn them off. When the switch is turned
on, a light on the switch illuminates. These switches
will only affect the spray system when the master boom
switch is on.
1. Boom switches, left, right
and center
2. Pump switch
3. Application rate switch
Pump Switch
The pump switch is located on the control panel to the
right of the seat (Figure 13). Toggle this switch forward
to run the pump or rearward to stop the pump. When
the switch is turned on, a light on the switch illuminates.
Important: Only engage the pump switch when
the engine is at low idle to avoid damaging the
pump drive.
Application Rate Switch
The application rate switch is located on the control
panel to the right of the seat (Figure 13). Press and hold
the switch forward to increase the spray system pressure,
or press and hold it rearward to decrease pressure.
Boom Lift
The boom lift switches are located on the control panel
to the right of the seat and used to raise the left and right
boom respectively (Figure 13).
Sonic Boom (Optional)
The Sonic Boom switch is a rocker switch used to
operate the Sonic Boom. Toggle switch forward for
automatic, rearward for manual and center for Off. The
sprayer comes with plastic plugs in these locations.
17
Figure 13
4. Agitation
5. Boom lift switch, left and
right