Maintenance; Recommended Maintenance Schedule(S) - Toro 41582 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
After the first 8 hours
After the first 50 hours
After the first 200 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 400 hours
Maintenance Procedure
• Replace the hydraulic oil filter.
• Torque the wheel lug nuts.
• Change the rear planetary gearbox fluid.
• Check the fan/alternator belt
• Change the engine oil (including synthetic oil) and oil filter.
• Pack the front wheel bearings.
• Check the air filter, cap, and valve for wear or damage.
• Check the engine oil.
• Check the tire pressure.
• Check the coolant level.
• Check the hydraulic oil level.
• Clean the suction strainer. (More often when using wettable powders)
• Lubricate all grease fittings (including the boom hinges).
• Check the fuel lines and connections.
• Check the battery cable connections.
• Service the air cleaner. (more often in dusty, dirty conditions).
• Inspect the condition and wear of the tires.
• Torque the wheel lug nuts.
• Check the cooling system hoses for wear and damage.
• Replace the engine oil filter.
• Change the engine oil, including synthetic oil (more often when operating under
heavy load or in high temperature).
• Check front wheel toe-in.
• Clean the radiator fins.
• Inspect all hoses and connections for damage and proper attachment.
• Grease the actuator rod bearings.
• Complete all yearly maintenance procedure specified in the engine operator's
manual.
• Drain and clean the fuel tank.
• Check the fuel lines and connections.
• Replace the fuel filter/water separator canister.
• Replace the fuel filters.
• Pack the front wheel bearings.
• Change the planetary gearbox fluid.
• Check the coolant (as directed by the manufacturer) and change if necessary.
• Replace the hydraulic oil filter.
• Change the hydraulic oil.
• Inspect the O-rings in the valve assemblies and replace them if necessary.
• Inspect the pump diaphragm and replace if necessary (see an Authorized Toro
Service Distributor).
• Inspect the pressure dampener bladder and replace if necessary (see an Authorized
Toro Service Distributor).
• Inspect the pump check valves and replace if necessary (see an Authorized Toro
Service Distributor).
• Check boom actuator hydraulic oil for air bubbles.
29