Operation; Think Safety First; Performing Pre-Starting Checks; Preparing To Drive The Machine - Toro 41594 Operator's Manual

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions and decals
in the safety section. Knowing this information could help
you or bystanders avoid injury.
Performing Pre-Starting
Checks
Check the following items each time you begin using the
sprayer for the day:
•
Check the tire pressure.
Note: These tires are different than car tires; they require
less pressure to minimize turf compaction and damage.
•
Check all fluid levels and add the appropriate amount of
specified fluids, if any are found to be low.
•
Check the brake pedal operation.
•
Check to see that the lights are working.
•
With the engine off, check for oil leaks, loose parts, and
any other noticeable malfunctions.
If any of the above items are not correct, notify your mechanic
or check with your supervisor before taking the sprayer out
for the day. Your supervisor may want you to check other
items on a daily basis, so ask what your responsibilities are.

Preparing to Drive the Machine

Checking the Tire Air Pressure
Service Interval: Before each use or daily
Check the tire air pressure to ensure proper levels. Fill the
tires to 124 kPa (18 psi).
Note: Also, check the tires for wear or damage.
Checking the Engine Oil
Service Interval: Before each use or daily Check the engine
oil level before you start the engine for
the first time.
Engine oil specification:
•
Oil type: API service classification SL or higher.
•
Oil viscosity: refer to the engine oil viscosity table below.
Engine Oil Viscosity Table
Ambient temperature range
Above 25 C (77 F)
0 C to 25 C (32 F to 77 F)
0 C to 20 C (32 F to -4 F)
Toro Premium Engine Oil is available from your distributor
in either 15W40 or 10W30 viscosity. Refer to the Parts Catalog
for part numbers.
Note: The best time to check the engine oil is when the
engine is cool, before it has been started for the day. If it has
already been run, allow the oil to drain back down to the
sump for at least 10 minutes before checking.
The engine is shipped with oil in the crankcase; however, the
level of oil must be checked before you first start the engine
and after you have run it.
1. Position the machine on a level surface.
2. Remove the dipstick, located under the passenger seat,
and wipe it with a clean rag
Note: Insert the dipstick into the tube and make sure
it is seated fully. Remove the dipstick and check the
oil level.
22
Oil viscosity
SAE30, SAE10W-30, or
SAE15W-40
SAE20 or SAE10W-30
SAE10W or SAE10W-30
(Figure 19).