Toro 41594 Operator's Manual page 41

Installing the Engine Heat Shield
1. Align the rear flange of the forward heat shield over the
forward flange of the rear heat shield
Figure 49
1. Front of the machine
2. Hex-head bolts and
washers
2. Align the holes in the forward heat shield with the
threaded holes in the chassis
3. Assemble the forward heat shield to the machine with
the 6 hex-head bolts and 6 washers
you removed in step
Shield (page 40).
4. Torque the bolts to 1129 to 1582 N·cm (100 to 140
in-lb).
5. Lower the machine and remove the jack stands.
Removing the Seat Base Access Panel
1. Remove the 2 flanged-head bolts that secure the seat
base access cover to the seat base
(Figure 49).
3. Rear flange (forward heat
shield)
4. Forward flange (rear heat
shield)
(Figure 49).
(Figure 49) that
4 of Removing the Forward Heat
(Figure 50).
1. Acoustic panel
2. Seat base access cover
2. Remove the seat base cover and the acoustic panel
from the machine
Installing the Seat Base Access Panel
1. Align the acoustic panel to the opening in the seat base
for the seat base access cover
2. Align the holes in the seat base access cover with the
holes in the seat base
3. Assemble the seat base access cover to the seat base
with the 2 flanged-head bolts
removed in 1 in
(page 41).
4. Torque the bolts to 1975 to 2542 N-cm (175 to 225
in-lb).
41
Figure 50
3. Flanged-head bolt
4. Hole (seat base)
(Figure 50).
(Figure 50).
(Figure 50).
(Figure 50) that you
Removing the Seat Base Access Panel