Toro 41594 Operator's Manual page 69

3. Align the flange of the master boom valve manifold, 1
gasket, and the agitation valve manifold (B of
98).
4. Assemble the master boom valve manifold, gasket, and
agitation valve manifold with a clamp tightened hand
tight (B of Figure 98)
5. Align the flange of the master boom valve manifold, 1
gasket, and the 90° flanged elbow (at the end of the
hose for the flow meter; refer to B of
6. Assemble the master boom valve manifold, gasket, and
90° flanged elbow with a clamp tightened hand tight
(B of Figure 98).
7. Assemble the agitation valve to the valve mount with
the flanged-head bolt and flanged locknut that you
removed in step 2
Valve (page 64) and torque the nut and bolt to 1017 to
1243 N-cm (90 to 110 in-lb).
Installing the Section Manifold Valve
1. Insert the upper endcap fitting of the manifold valve
into the bypass fitting (A of
Note: If needed, loosen the mounting hardware for
the bypass valve as needed to provide clearance.
1. Flange (reducer coupling)
2. Socket (bypass fitting)
3. Bypass valve
4. Flange (adjacent
manifold—agitation valve)
5. Endcap fitting (manifold
valve assembly)
2. Secure the endcap fitting to the bypass fitting by
inserting a retainer into the socket of the bypass fitting
(A of Figure 99).
3. Assemble the outlet fitting onto the lower endcap
fitting of the manifold valve (A of
Figure
of Removing the Section Manifold
Figure 99).
Figure 99
6. Socket (outlet fitting)
7. Retainer
8. Flange (manifold—section
valve)
9. Gasket
10. Flange clamp
Figure 99).
4. Secure the endcap fitting to the outlet fitting by
Figure inserting a retainer into the socket of the outlet fitting
(A of
5. Align a 1 gasket between the flanges of the reducer
coupling and the section valve manifold (B of
99).
6. Assemble the reducer coupling, gasket, and section
valve manifold with a clamp tightened hand tight ( B of
98).
Figure
7. If installing the 2 left most section valves, align a 1
gasket between the flanges of the 2 adjacent section
valve manifolds (B of
8. Assemble the and 2 adjacent section valve manifolds
and gasket with a clamp tightened hand tight (B of
Figure
9. For the left or right boom section valves, assemble
the valves to the valve mount with the flanged-head
bolt and flanged locknut that you removed in step
of Removing the Section Manifold Valve (page 64)
and torque the nuts and bolts to 1017 to 1243 N-cm
(90 to 110 in-lb).
10. If you loosened the mounting hardware for the bypass
valve, tighten the nut and bolt to 1017 to 1243 N-cm
(90 to 110 in-lb).
Installing the Valve Actuator
1. Align the actuator to the manifold valve and
82).
2. Secure the actuator and valve with the retainer that you
removed in step
(page
3. Connect the 3-pin connector of the valve actuator
harness to the 3-socket connector of the wiring harness
of the sprayer
69
Figure 99)
99).
Figure 99).
99).
3 of Removing the Valve Actuator
61).
Figure
3
(Figure