Toro 41594 Operator's Manual page 47

Figure 61
1. Screws (#10 x 5. 2-pin
3/4 inch) connector (fuel
pump/sending
unit)
2. Cover 6. 2-pin connector
(machine-wiring
harness)
3. Fuel tank 7. 2-socket
connector (fuel
pump/sending
unit)
4. 2-socket 8. Nut (fuel
connector pump/sending
(machine-wiring unit)
harness)
3. Disconnect the 2-socket connector of the
machine-wiring harness from the 2-pin connector
of the fuel pump/sending unit; disconnect the 2-pin
connector of the machine-wiring harness from the
2-socket connector of the fuel pump/sending unit
(Figure 61).
4. Slide the locking sleeve of the fuel-hose coupling away
from the fitting of the fuel pump/sending unit and
remove the coupling and hose from the fitting
61).
Note: Clean up any fuel that flows from the hose
coupling or fuel-pump fitting.
9. Seal
10. Fuel-hose
coupling
11. Fitting (fuel
pump)
(Figure
47
5. Rotate the nut for the fuel pump/sending unit
counterclockwise and remove the nut and seal
61)
6. Carefully lift and rotate the fuel pump/sending unit out
of the neck of the fuel tank
Important: Use caution when handling the fuel
pump/sending unit to avoid damaging the arm
for the float of the sending unit.
Figure 62
1. Fuel tank neck
2. Arm (sending unit float)
3. Pickup tube (fuel filter)
(Figure
(Figure 62).
4. Fuel pump/sending unit
5. Filter
6. Float