Toro 41594 Operator's Manual page 57

1
Figure 77
1. Hydraulic tank
3. Place a large pan under the fitting.
4. Remove the hose fitting from the tank, allowing the oil
to drain into the pan
5. Install the hose and fitting to the tank and tighten it
securely.
6. Fill the hydraulic reservoir with approximately 53 L (14
US gallons) of specified hydraulic fluid or equivalent,
see Hydraulic Fluid Specification (page
7. Start the machine and run it at idle for 3 to 5 minutes
to circulate the fluid and remove any air trapped in
the system.
8. Stop the engine, check the hydraulic oil level, and check
for leaks.
9. Dispose of the used oil at a certified recycling center.
Checking the Hydraulic Lines and
Hoses
Inspect the hydraulic lines and hoses daily for leaks, kinked
lines, loose mounting supports, wear, loose fittings, weather
deterioration and chemical deterioration. Make all necessary
repairs before operating.
2
G014219
2. Hydraulic hose and fitting
(Figure 77).
55).
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Ensure that all hydraulic fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
• Keep your body and hands away from pin
hole leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic leaks.
• Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
• Get immediate medical help if fluid is injected
into skin.
57