Toro 41594 Operator's Manual page 23

Figure 19
1. Front of the machine
2. Oil filler cap
3. If the oil level is low, remove the filler cap from the
valve cover (Figure 19) and pour oil into the filler neck
until the oil level is up to the Full mark on the dipstick.
Note: Add the oil slowly and check the level often
during this process. Do not overfill.
4. Install the filler cap (Figure
5. Install the dipstick firmly in place
3. Dip stick
19).
(Figure 19).
Checking the Coolant Level
Service Interval: Before each use or daily Check the level of
coolant in the radiator and the expansion
tank at the beginning of each day before
starting the engine.
Coolant type: a solution of 50% soft water and 50% long
life ethylene glycol antifreeze
CAUTION
If the engine has been running, the coolant may
be hot and pressurized. If you open the radiator
cap when the coolant is hot, it could spray out and
severely burn you or bystanders.
Allow the engine to cool for at least 15 minutes
before opening the radiator cap.
1. Position the sprayer on a level surface.
2. Set the parking brake, stop the pump, stop the engine,
and remove the key from the starter switch.
3. Carefully remove the radiator cap and the expansion
tank cap (Figure
1. Radiator cap
2. Expansion tank
4. Check the coolant level in the radiator and in the
expansion tank.
Note: The radiator should be filled to the top of the
filler neck and the expansion tank filled to the Full
mark on the tank
23
20).
Figure 20
3. Expansion tank cap
4. Full line, expansion tank
(Figure 20).