Table of Contents
Advertisement
Controls System
Maintenance
Adjusting the Pattern Control
Cable for the Spreader
1. Stop the engine, set the parking brake, remove the key,
and wait for all moving parts to stop before leaving the
operating position.
2. Empty the hopper; refer to
(page 29)
3. Close the impeller gate by pushing the wide-distribution
impeller gate lever forward fully
Figure 82
1. Unlock—spread pattern
control handle (rotate
counterclockwise)
2. Push down—spread
pattern control handle
4. Rotate the spread pattern control handle
counterclockwise (1), push the handle down (2), and
rotate the spread pattern control handle clockwise(3)
refer to
Figure
82.
5. Loosen the jam nut at the end of the pattern control
cable
(Figure
83).
Emptying the Hopper
(Figure
82).
3. Lock—spread pattern
control handle (rotate
clockwise)
4. Push
forward—wide-distribution
impeller-gate lever
1. Jam nut (pattern control cable)
2. Linkage rod
3. Impeller shaft
4. 1/8 inch (3.2 mm) gap between ramp tooth and impeller
shaft
5. Ramp tooth
6. Pull the linkage rod until there is 1/8 inch (3.2 mm)
gap between the ramp tooth and the impeller shaft
(Figure
83).
7. Tighten the jam nut
8. Adjust the spread pattern control handle; refer to
Adjusting the Spreader Pattern (page
64
Figure 83
(Figure
83).
32).
Advertisement
Table of Contents
