Safety Instructions - Paramount Fitness ClearO3 Installation Manual

IMPORTANT SAFETY INSTRUCTIONS: READ COMPLETELY BEFORE PROCEEDING WITH
INSTALLATION. SAVE THESE INSTRUCTIONS
When using this electrical equipment, basic safety precautions should always be followed, including the
following:
CAUTION
• A qualified licensed electrician should perform electrical hookup.
• Turn off power at main source before making any electrical connections or servicing the unit.
• Use only liquid-tight flexible nonmetallic conduit for electrical connections.
• A terminal marked G is located inside the supply terminal compartment. To reduce the risk of electric
shock, this terminal must be connected to the grounding means provided in the electrical supply
service panel with a continuous copper wire equivalent in size to the circuit conductors supplying this
equipment.
• At least one lug marked "BONDING LUG" provided on the external surface of the unit. To reduce
the risk of electric shock, connect the local common bond grid in the area of the pool or spa to this
terminal with an insulated or bare copper conductor not smaller than 6 AWG.
WARNING
contacting electrical equipment. Install in accordance with the installation instructions.
• Short-term inhalation of high concentrations of ozone and long-term inhalation of low concentrations of
ozone gas can cause serious harmful physiological affects. Do not inhale gas produced by this unit. If
installed in an enclosed space make sure to account for adequate ventilation.
• UV LIGHT PRODUCED BY THIS UNIT IS HARMFUL TO THE EYES AND MAY CAUSE
BLINDNESS. DO NOT LOOK DIRECTLY AT A LIT BULB!
NOTICE TO INSTALLER/OWNER:
• Save these instructions and deliver to pool owner when installation is complete.
• Lamp contains mercury. Dispose of in accordance with local and state regulations.

SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS
• Follow all applicable electrical codes.
• ALWAYS wear safety glasses when using power equipment
during the installation process.
• Install at least 5 ft from pool or spa water using nonmetallic
plumbing. Mount ozone generator near pool equipment at least
one (1) foot above maximum water level to prevent water from
3