Table of Contents
Advertisement
IMPORTANT SAFETY INSTRUCTIONS: READ COMPLETELY BEFORE
PROCEEDING WITH INSTALLATION. SAVE THESE INSTRUCTIONS
When using this electrical equipment, basic safety precautions should always be
followed, including the following:
CAUTION: READ AND FOLLOW ALL INSTRUCTIONS
WARNING:
• Follow all applicable electrical codes.
• A qualified licensed electrician should perform electrical hookup.
• Turn off power at main source before making any electrical
connections or servicing the unit.
• Use only liquid-tight flexible nonmetallic conduit for electrical
connections.
• A terminal marked G is located inside the supply terminal
compartment. To reduce the risk of electric shock, this terminal must
be connected to the grounding means provided in the electrical supply
service panel with a continuous copper wire equivalent in size to the
circuit conductors supplying this equipment.
• At least one lug marked "BONDING LUG" provided on the external
surface of the unit. To reduce the risk of electric shock, connect the
local common bond grid in the area of the pool or spa to this terminal
with an insulated or bare copper conductor not smaller than 6 AWG.
WARNING:
• ALWAYS wear safety glasses when using power equipment during the
installation process.
• Install at least 5 ft from pool or spa water using nonmetallic plumbing.
Mount ozone generator near pool equipment at least one (1) foot
above maximum water level to prevent water from contacting electrical
equipment. Install in accordance with the installation instructions.
• Short-term inhalation of high concentrations of ozone and long-term
inhalation of low concentrations of ozone gas can cause serious
harmful physiological affects. Do not inhale gas produced by this unit.
If installed in an enclosed space make sure to account for adequate
ventilation.
SAFETY INSTRUCTIONS
3
Hide quick links:
Advertisement
Table of Contents
