Can-Am outlander 400 Operator's Manual page 124

TYPICAL
Properly reinstall removed parts in the
reverse order of their removal.
Beam Aiming Adjustment
Adjust beam aiming as follows:
Turn adjustment screws to adjust
beam height and side orientation to
your convenience. Adjust both head-
lamps evenly.
vmo2006-005-040_b
1. Headlamp cover
2. Adjustment screws
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious in-
jury or death.
_____________________
122
Taillight
Unscrew lens screws to expose bulbs.
1. Lens
2. Screws
Push the bulb in and hold while turning
counterclockwise to release.
Install the new bulb by first pushing in
while turning clockwise.
Speedometer
The speedometer is lighted with
LEDs. If one LED burnt, replace the
speedometer. The LEDs are not avail-
able separately.
WARNING