Special Procedures; Flooded Engine (Drowned Mode); Engine Overheat; Turn Over - BOMBARDIER outlander 800 Operator's Manual

Hide thumbs Also See for outlander 800:
Table of Contents

Advertisement

SPECIAL PROCEDURES

Flooded Engine (Drowned
Mode)
If the engine does not start and it is fuel-flood-
ed, this special mode can be activated to pre-
vent fuel injection and to cut ignition while
cranking. Proceed as follows:
Insert key in ignition switch and turn to ON.
Press completely and HOLD throttle lever.
Press the START button.
The engine should be cranked for 20 sec-
onds. Release START button.
Release throttle lever and start/crank engine
again to allow starting.
If it does not work:
Clean the spark plug caps area then remove
them. Remove the spark plugs (tools are sup-
plied in tool kit).
WARNING
Always wear eye protector and gloves
when cleaning the spark plug holes.
Crank engine several times. Install new spark
plugs if possible or clean and dry spark plugs.
Start engine as explained above. If engine
continues to flood, see an authorized
Bombardier ATV dealer.
86

Engine Overheat

If engine overheats and indicator light turns
on, try the following:
Check and clean radiator fins. See MAINTE-
NANCE section.
WARNING
The radiator can be very hot, wear gloves
before touching it.
Reduce vehicle speed but try to keep vehicle
moving to supply air to radiator. If engine is
still overheating after approximately one
minute, stop vehicle and set transmission to
PARK. Stop engine.
Place the ignition switch to ON position (DO
NOT RESTART ENGINE YET). The radiator
fan will cool the radiator.
Let engine cool down. Check coolant level
and refill if possible.
WARNING
Never refill cooling system when engine is
hot.
See an authorized Bombardier ATV dealer as
soon as possible.

Turn Over

When vehicle is turned over or stays tilted on
the side, replace the vehicle in its normal op-
erating position (on all four wheels) and wait
3 to 5 minutes before starting engine. Before
starting engine, check engine oil level and re-
fill if necessary. If the oil pressure light stays
ON after starting engine, stop engine and see
an authorized Bombardier ATV dealer as
soon as possible.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents