Lubrication; Lubricating The Machine; Greasing The Front Caster Pivots - Toro 74534TE GrandStand Operator's Manual

Lubrication

Grease with No. 2 lithium or molybdenum grease.

Lubricating the Machine

Service Interval: Every 50 hours—Grease the mower-deck
idler arms (more often in dirty or dusty
conditions).
Every 50 hours—Grease the lift linkage (more often
in dirty or dusty conditions).
1. Disengage the PTO and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag.
Note: Make sure to scrape any paint off the front of
the fitting(s).
4. Connect a grease gun to the fitting.
5. Pump grease into the fittings until grease begins to
ooze out of the bearings.
6. Wipe up any excess grease.
Use the following graphics for locating the grease points.
Figure 37
91 cm Mower Deck
102 cm Mower Deck
Greasing the Front Caster
Pivots
Service Interval: Yearly
1. Remove the dust cap and adjust the caster pivots; refer
to Adjusting the Caster-Pivot Bearing (page
Note: Keep the dust cap off until greasing is done.
2. Remove the hex plug.
3. Thread a grease fitting into the hole.
4. Pump grease into the fitting until it oozes out around
the top bearing.
5. Remove the grease fitting in the hole.
6. Install the hex plug and cap.
32
Figure 38
Figure 39
43).