Controls System Maintenance; Adjusting The Motion-Control Handle Positions - Toro 74534TE GrandStand Operator's Manual

Controls System
Maintenance
Adjusting the Motion-Control
Handle Positions
Adjusting the Right Motion-Control
Lever
If the motion-control levers do not align horizontally, adjust
the right motion-control lever.
Note: Adjust the horizontal alignment before the front to
back alignment.
1. Disengage the PTO, move the right motion-control
lever to the N
EUTRAL
brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Push the right motion-control lever down out of the
N - position
EUTRAL LOCK
4. Check if the right motion-control lever aligns
horizontally with the left motion-control lever
68).
Figure 68
1. Left motion-control lever
2. Right motion-control lever
in the N -
EUTRAL LOCK
position
Note: To adjust the right motion-control lever
horizontally, adjust the cam.
5. Release the cushion from the rear of the machine.
6. Loosen the nut holding the cam
position, and set the parking
(Figure 68).
(Figure
3. Check the horizontal
alignment here.
4. Right motion-control lever
(Figure 69).
1. Cam
7. Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the cam.
Note: Moving the cam clockwise (in the vertical
position) lowers the handle, while moving it
counterclockwise (in the vertical position) raises the
handle.
Important: Ensure that the flat portion of the
cam does not go above a vertical position (right or
left), or you may cause damage to the switch.
Adjusting the Neutral Position for the
Motion-Control Levers
Important: Ensure that the tracking of the mower
is correct after adjusting the motion-control levers.
Adjusting the tracking and aligning the motion-control
levers front to back is the same procedure
Note: Adjust the horizontal alignment before the front to
back alignment.
If the motion-control levers do not align front to back, or
the right side control lever does not move easily into the
N - position, adjustment is required.
EUTRAL LOCK
1. After you finish the horizontal alignment, check
the front-to-back alignment by slightly pushing the
motion-control levers forward to take up any slack in
the linkage for the control levers
49
Figure 69
2. Nut
(Figure
(Figure 70).
70).