Servicing The Fuses; Drive System Maintenance; Adjusting The Tracking - Toro 74534TE GrandStand Operator's Manual

6. Install the battery onto the machine and connect the
battery cables; refer to
Note: Do not run the machine with the battery
disconnected; electrical damage may occur.
Figure 53
1. Positive battery post
2. Negative battery post

Servicing the Fuses

The electrical system is protected by fuses. It requires no
maintenance. If a fuse blows, check the component or circuit
for a malfunction or short.
1. Release the operator cushion from the rear of the
machine.
2. Pull out on the fuse to remove and replace it
54).
3. Install the operator cushion.
Figure 54
1. Optional accessory
fuse—15 A
2. Power-takeoff (PTO)
fuse—10 A
Installing the Battery (page
3. Red (+) charger lead
4. Black (-) charger lead
(Figure
3. Charge fuse—25 A
4. Main fuse—30 A
Drive System
40).
Maintenance

Adjusting the Tracking

Note: Determine the left and right sides of the machine
from the normal operating position.
1. Push both control levers forward the same distance.
2. Check if the machine pulls to one side.
Note: If it does, stop the machine and set the parking
brake.
3. Release the cushion from the rear of the machine.
4. Rotate the right cable adjustment to position the right
motion-control lever in the center of the control-panel
neutral-lock slot
1. Left motion-control lever
2. Right motion-control lever
5. Rotate the left cable adjustment to match the left wheel
speed to the previously set right wheel speed.
6. Adjust in quarter-turn increments until the machine
tracks straight.
Note: Only adjust the left cable to match the
left wheel speed to the right wheel speed. Do not
adjust the right wheel speed as this positions the
right motion-control lever out of the center for the
control-panel neutral-lock slot.
41
(Figure 56).
Figure 55
3. Neutral-lock position
4. Align the control levers
front to back.
g015241