Belt Maintenance; Checking The Belts; Replacing The Mower-Deck Belt - Toro 74534TE GrandStand Operator's Manual

Adjusting the Brakes
If the gap between the brake bar and tire is not correct, adjust
the brake.
1. Park the machine on a level surface and disengage the
PTO, and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Release the parking brake; refer to
Parking Brake (page
4. To adjust the brake, remove the clevis pin and hairpin
cotter from the lower-brake lever and yoke
5. Adjust the yoke (Figure
Note: The distance between the brake bar and the tire
needs be between 3 and 6 mm (1/8 and 1/4 inches).
Note: To tighten the brake, rotate the yoke up. To
loosen the brake, rotate the yoke down.
6. Check the brake operation again; refer to
Parking Brake (page
7. Secure the yoke to the lower-brake lever with the clevis
pin and hairpin cotter
Figure 63
1. Yoke
2. Clevis pin
Releasing the
16).
(Figure
62).
Checking the
45).
(Figure 63).
g013291
3. Lower-brake lever
4. Hairpin cotter

Belt Maintenance

Checking the Belts

Service Interval: Every 100 hours—Check the pump-drive
Every 100 hours—Check the mower-deck belt(s).
Check belts for cracks, frayed edges, burn marks, wear, signs
of overheating or any other damage.
The signs of a worn mower belt are squealing while the belt
is rotating, blades slipping while you are cutting grass, frayed
63).
belt edges, burn marks, and cracks. Replace the mower belt if
you detect any of these signs.
Replacing the Mower-Deck
Belt
For Models with a 91 cm Deck
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns
so that the cover is loose but still attached, then go
back and loosen them until the cover comes free. This
prevents you from accidentally stripping the bolts free
of the retainers.
1. Disengage the PTO and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Loosen the bolts and remove the right belt cover with
the bolt attached to it.
4. Remove the spring from the anchor post on the
idler-pulley arm
5. Remove the worn mower belt
6. Install the new mower belt around the clutch pulley, the
deck pulleys, and the idler pulley
7. Install the spring onto the anchor post on the
idler-pulley arm
8. Install the belt cover onto the mower deck and secure
the bolt.
46
belt.
(Figure 64).
(Figure 64).
(Figure
(Figure 64).
64).