Changing The Engine Oil - Toro 74534TE GrandStand Operator's Manual

Changing the Engine Oil

Note: Dispose of the used oil at a recycling center.
1. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil drains
completely.
2. Disengage the PTO, move the motion-control levers to
the N -
EUTRAL LOCK
3. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 44).
4. Change the engine oil as shown in
Figure 44
5. Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil to
bring it to the Full mark
position and set the parking brake.
Figure 44.
g020534
(Figure 45).
A
C
E
Changing the Engine-Oil Filter
Note: Change the engine-oil filter more frequently when
operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to
Engine Oil (page
2. Place a rag under the oil filter to soak up any spilled oil.
Important: Spilled oil may drain under the engine
and onto the clutch. Oil spilled on the clutch may
damage the clutch, cause the blades to stop slowly
when the clutch is in the O
the clutch to slip when the clutch is switched to
the O position. Wipe up any spilled oil.
N
3. Change the engine-oil filter
36
B
D
F
g027660
Figure 45
Changing the
36).
position, and cause
FF
(Figure 46).