Servicing The Engine Oil - Toro 74534TE GrandStand Operator's Manual

Servicing the Engine Oil

Service Interval: Before each use or daily—Check the
engine-oil level.
After the first 8 hours—Change the engine oil.
Every 100 hours—Change the engine oil (more often
in dirty or dusty conditions).
Every 200 hours—Change the engine-oil filter (more
often in dirty or dusty conditions).
Note: There are different oil capacities for the different
models listed in this manual. Ensure that the correct amount
of oil is used.
Important: Add 80% of the oil and then gradually fill it
to the Full mark on the dipstick.
Oil Type: Detergent oil (API service SF, SG, SH, SJ or SL)
Engine Oil Capacity: 1.7 L (58 oz) with the filter removed;
1.5 L (51 oz) without the filter removed
Viscosity: Refer to the table below:
Checking the Engine-Oil Level
Note: Check the oil when the engine is cold.
WARNING
Contact with hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing and other body
parts away the muffler and other hot surfaces.
Important: Do not overfill the crankcase with oil
because damage to the engine may result. Do not run
engine with oil below the low mark because the engine
may be damaged.
1. Disengage the PTO, move the motion-control levers to
the N -
EUTRAL LOCK
Figure 42
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure
A
C
F
H
35
43).
g020534
B
D
E
G
I J
Figure 43
G027659