Operating The Choke; Operating The Ignition Switch - Toro 74534TE GrandStand Operator's Manual

Operating the Choke

Use the choke to start a cold engine.
1. If the engine is cold, use the choke to start the engine.
2. Pull up on the choke knob to engage the choke before
using the ignition switch
3. Push down on the choke knob to disengage the choke
after the engine has started
1
2
1. On position
(Figure 13).
(Figure 13).
G008959
Figure 13
2. Off position

Operating the Ignition Switch

Important: Do not engage the starter for more than
5 seconds at a time. If the engine fails to start, wait
15 seconds between attempts. Failure to follow these
instructions can burn out the starter motor.
Note: You may need to repeat the cycle for starting the
engine when you start it for the first time after you have filled
a completely empty fuel system with fuel.
18
Figure 14
Figure 15