2.2
Installation Procedures
2.2.1
Connecting Power Cord
The panel PC can only be powered through an DC electrical outlet (12 ~ 30 V). Be
sure to handle the power cord by holding the plug end only. Follow these procedures
to connect the power cord:
1.
Connect the female end of the power cord to the DC inlet of the panel PC.
2.
Connect the 3-pin male plug of the power cord to an electrical outlet.
2.2.2
Connecting Keyboard and Mouse
Connect the mouse and keyboard to the I/O connector of the panel PC.
2.2.3
Switching on Power
The power switch is located at the lower right corner on the rear cover of the panel
PC.
Figure 2.4 Connecting Power Cord
13
PPC-3100/3120 User Manual